Luminex xPONENT 3.1 Uživatelský manuál stáhnout pdf (Strana 66)

Luminex xPONENT 3.1 Software Manual

FIGURE 33. Analysis Settings Dialog Box

• Select a method from the Method list.

• If necessary, select a weight type from the Weight Type list.

• Apply the analysis to all analytes in the list by clicking Apply to All Analytes.

• Select Mark as Intra-Well Normalization Bead to make the analyte an intra-well

normalization bead.

• Add a range to the analysis by clicking Add Range.

• Select Use Threshold Ranges to enable ranges for the analysis.

• Click Add Range to add a range.

• Type a Range Name, a Low Value, a High Value, and select Inclusive if you wish

to include the low and high values in the range. Click OK to exit the dialog box.

• Units - The unit of measurement you specified in the Unit box. Click this box to type a

value for the analyte.

• Count - The total desired bead count for an analyte. Click this box to type a value. The

system continues analyzing until each bead set has met the minimum events as

determined in the Count box above. If you select the Stop after total bead count

reaches: check box and type a total count in the corresponding box, this column does

not appear.

• Region - Refers to the specific analyte selected. It is a number from 1 to 100.

Group. If you have selected Allele Call from the Analysis Type in the Settings tab, this

button displays. Click Group to group 2, 3, or 4 analytes for the group. Multiple groups can

be made.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 139 140

Žádné komentáře

Luminex xPONENT 3.1 Uživatelský manuál Strana 66